About Integrated light oil burner device

Filters - For oil type burners , it is required to clean the basket filter between the fuel tank and the fuel pump. Regular filter cleaning keeps fuel flowing smoothly to the pump and reduces the potential for component failure. Also inspect the filter for signs of excessive wear or damage.

Pressure Regulating Valve - Check the fuel pressure regulating valve or pressure reducing valve to determine if the surface of the lock nut on the adjusting bolt is clean and removable. If the surfaces of the screws and nuts are found to be dirty or rusted, the regulating valve should be repaired or replaced. Lack of maintenance on the fuel regulating valve can cause the burner to work poorly.

Oil Pump - Inspect the oil pump to determine if its seals are intact and if the internal pressure is stable, and replace damaged or leaking sealing elements. If hot oil is used, it is necessary to confirm whether all the oil pipes are well insulated; if there are long oil pipes in the oil circuit, it is necessary to check whether the installation route is suitable. Replace damaged and poorly insulated tubing.

Burners - For oil type burners, clean the "y" filter. Good filtration of heavy oil and residual oil is the key to preventing clogging of injectors and valves. Check the pressure difference on the burner to see if it is working properly and if the oil pressure is in the proper range, this will ensure that the fuel pressure can be read accurately after adjusting the burner. Adjust the extension length of the atomizer on the oil nozzle, adjust and detect the low oil pressure switch.

When using heavy oil, check the fuel heating and controls, and look at the oil temperature switch on the burner tube bank. Consult with the manufacturer on the oil viscosity required to ensure proper operation of the burner, and regularly check whether the viscosity of the heavy or residual oil used meets the requirements. It is also necessary to clean and lubricate the valve connections. If the connection is sticky or too rough, repair or replace with a suitable fitting. Finally, clean the grease nipples regularly as recommended by the manufacturer.

https://www.burners-china.com/