Attention to the use of heat conduction oil furnace burner

Precautions for using heat transfer oil furnace burners

In the heat transfer oil furnace burner industry, the cooling installation of heat transfer oil is undoubtedly very important. Whether a machine can be used for a long time depends on many aspects and how you maintain it. No matter how good the machine is, if I don't pay attention to maintenance, then the service life will be shortened. And there are many things that need to be paid attention to in the process of heating the heat transfer oil. Today, the heat-conducting oil furnace burner manufacturer will improve it for everyone:
1. When using, clean up the furnace and tube first to remove impurities, rust and moisture in the furnace to ensure that the equipment used is clean. the
2. Before the heat transfer oil in the circulation pipe enters the heater, a 30-40 mesh stainless steel wire filter should be installed to filter out possible impurities and residual carbon (clean the filter 2-3 times during cold oil circulation and normal operation. ) is very important. the
3. The equipment must be equipped with high and low tanks. The temperature of the high tank must be below 80 degrees, and the function of the low tank should be fully utilized. When a sudden power failure occurs, the valve of the heating device should be turned off immediately and the valve of the high tank should be opened to let the cold oil in the high tank be injected. After heating the equipment, it flows to the lower tank, which not only maintains the heating equipment but also ensures that the oil film does not exceed the temperature. The upper tank also serves to store the heat transfer oil in the system that increases due to heat shrinkage during heating, and at the same time isolates the atmosphere from the high temperature heat transfer oil. The direct contact ensures that the heat transfer oil will not be over-oxidized and prolongs the service life of the heat transfer oil. the
4. When the high tank is injected with cold oil, the temperature drops below 80 degrees before refueling to prevent bumping and hurting people. the
5. Since the equipment of each heat-conducting oil furnace is different, the use plan must separate the actual conditions of each heat-conducting oil furnace.www.burners-china.com