Cause of ignition failure of industrial burners

Now that we are entering the cold winter, more industrial burners are put into use. However, as the number of them used increases, there are always a few machines that may malfunction. A common burner failure is a combustion failure. When the burner When a problem occurs, we cannot determine the cause of the burner failure. At this time, we need to start the burner three times at a time. If the three starts fail to ignite the fuel, then there is a combustion failure. At this time, we need to respond accordingly related equipment to check for faults. ​
There are many points to be checked. First, check whether the fan can operate normally during combustion and whether the program is correct. There may also be a malfunction in the air source. It is abnormal for the air source to be lower or higher than 3-5kpa. Whether it is too low or too high, there will be some misfire. In addition to these two aspects, the burner's damper is also an important object to be inspected. We need to check the size of the burner's damper. When the burner's damper is large, it will also cause combustion failures, and there is the combustion electrode. Failure or excessive pollution are the causes of combustion failure. ​
When a burner fails, there are many solutions that can be used. We can first contact the staff engaged in power detection to check the power supply and wiring of the burner. Then change the burner temperature and pressure settings. Another reason is that the program controller of the burner has not been reset. We need to reset it from the beginning when using it. The internal parts of the burner have overheat protection after long-term operation. At this time, we have to wait for the temperature to drop before resetting the burner relay. ​
The above content is the combustion failure problem that is basically encountered during the use of industrial burners and some simple solutions to this problem. Therefore, the above mentioned is only part of the solution to the problem. When these methods have been used, it has not yet been solved. When solving problems, you can ask SWT Burner related technical personnel to assist in repairing them.www.burners-china.com

​