Daily Maintenance Of The Boiler Burners For Commercial
Aug 22, 2022
1. Daily Maintenance Of The Boiler Burners For Commercial
1) Always keep all surfaces clean.
2) When the equipment is stopped, lubricate each rotation of the quick-opening blind plate (flange cover) in time according to the regulations. The lead screw of the opening and closing part should be coated with grease. Other parts should also be coated with grease. For those that cannot be lubricated For grease parts, 10# or 20# oil can be injected.
2. Maintenance and maintenance during operation
1) It is recommended that the operator be responsible for the usual maintenance of the equipment.
2) Always keep the surface of the equipment clean.
3) Monitor the reading of the differential pressure gauge at any time. When the differential pressure in use reaches 0.02Mpa, the filter element should be flushed.
3. Inspection cycle
1) The periodic inspection of this equipment must be carried out in strict accordance with the relevant provisions of Chapter 6 of the "Regulations".
2) Carry out a comprehensive inspection of the equipment at least once a year, the measurement of the wall thickness of the equipment, and the non-destructive testing of the pressure welding seam of the equipment every two years. All inspection and testing results shall be recorded in the technical file of the equipment.
3) When there is pressure inside the device. Do not perform any maintenance. For repairs under special circumstances, the provisions of Article 122 of the "Regulations" must be strictly followed.
4. Maintenance while parked
1) When the equipment is parked, the liquid in the equipment should be drained.
2) Close all valves.
3) Thoroughly clean the surface of the equipment.
4) All rotating parts are coated with anti-grease.
5) Cover all the equipment with canvas to prevent dirt from depositing on the surface of the equipment.
