How to start the gas Low Nitrogen Burner
Dec 12, 2022
The main fuels of gas burners are natural gas, liquefied petroleum gas, city gas and other combustible gases. safety incidents. the
Start-up operation of natural gas low nitrogen burner:
1. For the newly installed furnace body, carefully check whether the gas meets the requirements of the burner before commissioning; check whether the detection equipment on the gas supply pipeline is normal and whether the pipeline valve is opened and closed normally, and whether it is convenient for future use and maintenance.
2. For newly installed pipelines, the installation reliability and tightness of all pipelines should be carefully checked.
3. Users who use a separate gasification station must ensure that the gas supply volume and gas supply parameters meet the requirements for safe combustion.
4. Operators carefully read the equipment instruction manual and master the knowledge and methods of safe operation.
5. Before each start-up, check whether the gas valve is open, otherwise the burner will not work.
6. Start the power control button on the control cabinet, and the digital display will display the current temperature in the furnace at this time, and the temperature of the newly installed furnace body is the ambient temperature.
7. Start the fan control button, and the fan installed on the furnace body will work. At this time, if the fan damages the control cabinet, it will be automatically protected from entering the next step.
8. When the combustion-supporting fan works without abnormality, start the combustion control button again, and the combustion program controller starts to work at this time, and it performs ignition, air supply, flame detection, and other procedures through a certain program to finally realize safe combustion.
9. When the combustion controller receives a signal that is not conducive to combustion, etc., the combustion controller immediately shuts off the gas and sends an alarm signal. 10. If the combustion controller alarms, it must be manually reset by the operator after the fault is resolved before it can continue to work.
11. For the operation of the entire equipment, the operator should refer to the furnace safety operation regulations and production process requirements for operation.
12. When the control temperature needs to be adjusted according to the requirements of the production process, the operator should refer to the manual of the intelligent numerical control table for adjustment.
