Start up operation of industrial gas burner

1. For newly installed furnaces, before commissioning, you should carefully check whether the gas meets the requirements of industrial burners; check whether the detection instruments on the gas supply pipeline are normal and whether the pipeline valves can be opened and closed normally, and whether they can be convenient for future use and maintenance. ​
2. For newly installed pipelines, the installation reliability of all pipelines and the sealing of the pipelines should be carefully checked. ​
3. Users who use a separate gasification station must ensure that the gas supply volume and gas supply parameters meet the requirements for safe combustion. ​
4． Operators must carefully read the equipment operating instructions and be proficient in safe operating knowledge and methods. ​
5. Check whether the gas valve is opened before each start-up, otherwise the boiler burner will not work. ​
6.Turn on the power control button on the control cabinet. At this time, the digital display will show the current temperature in the furnace. This temperature of the newly installed furnace body is the ambient temperature. ​
7.Turn on the fan control button and the fan installed on the furnace body will work. At this time, if the fan is damaged, the control cabinet will be automatically maintained and will not enter the next step. ​
8. When the combustion fan works without abnormality, start the combustion control button again. At this time, the combustion program controller starts to work. It stops ignition, air supply, flame detection, and other procedures through certain procedures to complete safe combustion. ​
9. When the combustion controller receives a signal that is not conducive to combustion or other problems, the combustion controller immediately turns off the gas and sends an alarm signal. ​
10. If the combustion controller alarms, it must be manually reset by the operator after the fault is resolved before it can continue to work. ​
11. For the operation of the entire equipment, the operator should refer to the furnace safety operating procedures and production process requirements to stop the operation. ​
12. When adjusting the control temperature according to the industrial burner production process requirements, the operator should refer to the intelligent CNC meter manual for adjustment.www.burners-china.com